Home About us News

News

Gen2020(v2.3) & Design+2020(v2.3) official patch

  • Date Posted
  • 2020.09.10
  • Count

Dear clients,


This patch has fixed and improved the following errors found in Gen 2020 (v2.1), Build date: May.18. 2020


1. In the shear design of slab member, the horizontal reinforcement was not taken into account. 


2. In the flexural design of shell member, the additional rebars were applied unnecessarily although basic rebars were sufficient to resist the bending moments.


3. In the RC design as per NTC 2018, Code check for Non-dissipative elements was not run.


4. Steel design as per IS has been improved to apply different material strengths depending on the thickness of steel component.


5. Wall design as per NSR-10 has been improved so that boundary elements can be applied in DMO system.


6. ‘Period Lock’ system has been introduced for license check.



This patch has fixed and improved the following errors found in Design+ 2020(v2.2), Build date: May. 22, 2020


1. There was an error when checking the thickness limit in the aluminum design.


2. The minimum rebar ratio (ρmin) was not applied when SRC column was subjected to the tensile force.


3. In the strip footing design according to EC2:2004, there was an error in calculating MEd and VEd per unit width.


4. There was an error in the application of the strength reduction factor when calculating the flexural strength according to AISC-ASD05.


5. Steel design as per EN/EN 05 has been improved to apply different material strengths depending on the thickness of steel component. (New)


6. ‘Period Lock’ system has been introduced for license check. (New)